Licensed electrical contractor — we install the equipment we sell

832-257-1977 ·  david@zapdaddyelectric.com

Licensed electricians, not a call center

Free freight on standby generators

Generator, switch and wire in one order

Specs checked against the manufacturer

Whole House or Essential Circuits? The Decision That Halves Your Bill

This is the first decision to make, and it has a bigger effect on what you spend than the brand you choose. Backing up your whole panel versus backing up the circuits that matter can be the difference between a $7,000 project and a $14,000 one — and for a lot of houses the cheaper option is genuinely the right one.

What each one means

Whole house means the generator carries the entire electrical panel. A ten-second pause while it starts, then everything works as normal. You would not know the power was out except for the noise outside.

Essential circuits means an electrician moves selected circuits to a sub-panel fed by the generator. Heat, refrigeration, water, some lights and outlets stay on. The air conditioning, the electric range, the hot tub and half the receptacles do not.

Where the money actually goes

Essential circuitsWhole house
Generator10–14 kW, around $3,400–$4,50022–26 kW, around $5,350–$7,000
Transfer switchLoad-centre or 100 A, $400–$650200 A service-rated, $855–$1,900
Gas supplyOften works on existing meterFrequently needs a meter or line upgrade
Electrical labourLower — fewer circuits movedHigher
Concrete padSmallerLarger
Typical all-in$7,000–$10,000$12,000–$18,000
Equipment prices are ours; installation figures are typical ranges and vary widely by site.

The gas supply line is the one that surprises people. A 22kW unit can need more gas than your existing meter delivers, and a utility meter upgrade is a separate job with its own timeline.

Choose essential circuits if

  • Your outages are measured in hours, not days
  • Your heat and hot water are gas — that removes the two largest loads
  • You can live without air conditioning for a day
  • The budget is the binding constraint
  • You are on a well and mainly need the pump, the furnace and the fridge

Choose whole house if

  • Outages where you live run for days
  • You are often away when they happen — nobody is there to manage load
  • Your home is all-electric, so heat and hot water are on the generator whatever you do
  • Someone in the house has a medical need
  • You are in a climate where losing AC in summer is a genuine health risk
  • You plan to sell — whole-house backup is the one buyers recognise

The middle road most people are not told about

You can get most of whole-house coverage at closer to essential-circuit cost by adding load management. A smart transfer switch or a load manager module sheds the air conditioning for a minute when capacity gets tight, then brings it back.

The practical effect is that a 22kW unit covers a house that would otherwise need 30kW or more. The saving comes out of the generator, the switchgear, the gas supply and the pad all at once, and it frequently pays for itself at the point of purchase rather than over time.

The trade is that under peak demand the AC waits its turn. Most people never notice. If you have equipment that genuinely cannot be interrupted, size the generator properly instead.

Work out your number first

Before you decide, find out what you actually need. The sizing calculator has both modes — run it as whole house, then run it again ticking only the circuits that matter, and compare. For a lot of houses the second number lands a full size class lower.

Not sure which way to go? Use the generator sizing calculator — it sizes against the fuel you will actually run — or send us your numbers and a licensed electrician will check them before you spend anything.

Frequently Asked Questions

Is a whole house generator worth it?

If your outages last days, you are often away when they happen, or your home is all-electric, yes. For a gas-heated home with short occasional outages, essential circuits often delivers most of the benefit for roughly half the total project cost.

How many circuits can an essential circuit generator run?

It depends on the switch, but typically 8 to 16 circuits. The usual set is furnace, refrigerator, well or sump pump, a few lighting circuits and some receptacles.

Can I add circuits later?

Up to the capacity of the generator and the transfer switch, yes. That is the argument for not buying the smallest possible unit — a little headroom now is far cheaper than replacing the set later.

Related reading