Licensed electrical contractor — we install the equipment we sell

832-257-1977 ·  david@zapdaddyelectric.com

Licensed electricians, not a call center

Free freight on standby generators

Generator, switch and wire in one order

Specs checked against the manufacturer

Generac · Kohler · Briggs & Stratton · Cummins · Southwire

Generators, sold by the people who install them.

Standby and portable generators, transfer switches, and the wire that connects them — specified by a licensed electrical contractor, priced below the big catalog sites.

  • Licensed electricians on the phone
  • Free insured freight
  • Houston installation available
Generac 7329 28kW home standby generator beside its 200A service-rated automatic transfer switch and wireless monitor Generac 28kW, shown with its 200A service-rated ATS — we ship both together

Home standby, ready to configure

Pick the output and the transfer switch together. Every price shown is the manufacturer’s advertised figure — your price appears in the cart.

Swipe products

Why buy from an electrician

Most sites selling generators have never installed one.

We size it with you

Square footage, AC tonnage, whether heat and water are gas or electric. Five minutes on the phone beats a return freight charge.

We know what the inspector asks

Service-rated or not. NEC 445.13 on the conductors. Burial depth. Working clearance. We have been through the inspection.

The whole job ships together

Generator, switch, wire and parts from one order, so your installer is not waiting on a part from a third supplier.

Free insured freight

Standby generators ship free to the lower 48, insured, delivered curbside by appointment.

Swipe

The part most sites skip

A $7,000 generator is a $15,000 project.

Nobody tells you that before you buy. Then the electrician quotes the install, the gas fitter quotes the line, and the number more than doubles.

We would rather you knew up front. Ask us for the whole-project figure before you order anything — it is a cheaper conversation than finding out later.

What a whole-house install actually costs
Generator (26kW air-cooled)from $7,000
200A service-rated transfer switch$850 – $1,900
Wire, conduit and fittings$300 – $900
Concrete or composite pad$300 – $700
Gas line and meter upgrade$800 – $2,500
Electrical labor$1,500 – $3,500
Permit and inspection$150 – $600

Typical ranges for a whole-house install. Yours depends on gas supply, panel location and run distance — ask and we will narrow it down.

Common questions

What size generator do I need?

It is decided by starting surge, not running watts — a 5-ton air conditioner can pull 16,000 W for a second on start. Add the running load of everything that must work at once, then add the single largest starting surge. Our sizing calculator does the arithmetic, or call and an electrician will work it through with you.

Do I need a transfer switch as well?

Yes — there is no standby install without one, and it is a legal requirement, not an upgrade. The size follows your service and the generator output, not the other way round. See what size transfer switch you need.

Why is the price only shown in the cart?

Manufacturers set a minimum advertised price. We advertise at that figure and apply our real price at the cart, which is where the restriction stops applying. Add the item to your cart and the discount shows before you pay anything.

What does installation actually cost?

The equipment is roughly half the project. Pad, gas line, wire, labor and permit usually add $3,000–$8,000 on a whole-house install. We would rather you knew up front — read what a standby generator really costs installed.

Do you install, or only ship?

Both. We ship nationwide with free insured freight on standby generators, and we install across the Houston metro — Katy, Sugar Land, The Woodlands, Cypress, Spring, Pearland and the surrounding area.

Talk to an electrician before you order.

Tell us the property, the loads and the service. We will tell you the generator, the switch and the wire — and what the install will cost.